Interested to Buy Any Domain ? << Click Here >> for more details...
Why short circuit calculation is not required in LT cable
sizing and requiredin HT cable sizing only
- 2 Answers
- 12133 Views
- Chemtex, I also Faced
- E-Mail Answers
Answer Posted / xyz
Short Circuit withstand capacity is to be checked for HT
cables. For LT breaker controlled motor feeders, the cable
impedance reduces short circuit current considerable, hence,
short circuit withstand capacity is not required to be
checked for the rated fault level of the LT motors.
| Is This Answer Correct ? | 3 Yes | 5 No |
Post New Answer View All Answers
what is acceptable leakage current for 33kv cable while doing high voltage test for cable? how to calaulate the leakage current for 33kv or any rated cable?
What is meant by load angle of an alternator? Upon what factors does the load angle depend?
Define stepper motor. What is the use of stepper motor?
how ceiling fan worked?
What current position are you holding in your current company?
how flow current in 220 kv line to line
plz send me the syllabus or any sample paper for engineer trainee recruitment if any,on ravinder911@yahoo.com
application s to shunt coil
1)How much current can a 3-1/2 core 100 mm wire carry? 2)What are the special cables required for explosion proof wiring? 3)In case you do not have coal and salt for earthing, how can you achieve good temporary earthing? 4)One horse power single phase motor is more likely to get hot than a one horse power 3 phase motor. Is it true or false, if true why? 5)What are the different types of soft starters for large motors?please explain?
i need mat lab program to find out the transmission line losses,regulation and losses
WHY TERTIARY OF POWER TRANSFORMERS IS LOADED WITH EQUIPMENTS LIKE CT,PT,ISOLATOR AND CB
Please explain me abt PQ diagaram in the power sector.
we have one oven for 12 zone we are installed ir lamp in oven we control load from thyrister and 0 to 5vdc so our zone no 8 getting bright in fraction of second so what we do.. Please answer
An automatic water heater is an example of which type of control system?
which phase is preferred for connecting 1 phase vt used for synchronizing OHL? WHY?
