Interested to Buy Any Domain ? << Click Here >> for more details...
what is the job description of a LOW CURRENT ELECTRCIAL
ENGINEER in a industry?
- 1 Answers
- 16286 Views
- BTAT, Powercraft, Prince Glass, Sterling, I also Faced
- E-Mail Answers
Answer Posted / perwez
Low Current engineer's ae refered as Electronic Engineer's
who are dealing with mile-amps(electronic components)
| Is This Answer Correct ? | 48 Yes | 10 No |
Post New Answer View All Answers
how does a shunt reactor maintains the bus voltage???
A 10 MVA, 66KV, 50Hz, Y-connected 3-phase alternator has synchronous reactance of 0.635 Ù. It is working at full load at 0.8 lagging p.f. condition. Find torque angle, neglect armature resistance.
Why the power factor improvement is so important in industrial loads
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
What is deference between MCB & MCCB & ISOLATOR
sir vizag steel ka junior trainee ka paper kitne number ka ayega
what is mean by parallel operation of permanent magnet generators
Transformer cores are laminated in order to A simplify its construction B minimize eddy current loss C reduce cost D reduce hysterisis loss
Is a d.c.compound motor is use as a booster? how?
What should be the percentage increase in length of the dead end clamp for bus bar conductor (Hawthorn) after hydraulic pressing and what should be the applied pressure?
when will be the iocl interview results i faced interview on 8th september 2008 iam from electrical branch i faced interview for the post of electrical engineer??????????????????????//
why industry prefer ht motor instead of lt motor.
how u select control transformer for a mccb panels or any panels?for expample we hav 440 volts maim supply and control volts is 230v?
How is efficiency of DG set calculated? At many places I found the efficiency to be mentioned in percentage. But at some other places I found kWH/ litres. I want to know how dimensionless percentage value is arrived at?
Installation resistance for whole installation of 16 kva & 25 KVA DTRA a) Between each conductor b) between conductor to earth c) installation resistance for each apparatus, each conductor to earth d) earth resistance for the system of earthing
