There are 2 motors without name plate and terminal but one
is DC motor and another is induction motor.How one can
identify which one is DC and which one is AC motor?
Answer Posted / pandi
there is a one way u have to check the rotor if the
commutator and brush assembly present in dc motor but not in
AC motor .
but in size dc motor size quit large compare then Ac motor
and also usually Ac motor has outer cooling fins and blower
which is fixed on shaft in case of dc motor forced air
cooled inside the motor in-order to dissipate the heat .
Is This Answer Correct ? | 12 Yes | 4 No |
Post New Answer View All Answers
How to calculate that clean water supply in one Day from 150 KLD STP?
how to calculate regulation constants for over head lines? and what are the regulation constant for raccoon conductor at different voltage level and different P.F?
hai now i am working as a electrical design engineer in construction field can i get a job in oil and gass field or power plant project as a electrical design engineer?
Can a generator runs after getting 1st stator earth fault.
What are the electrical engineer roles and responsibilities in chemical plant?
i have some screw comprressor with 630kw power,i have established them with simple star to delta circuit,by the way there is so much inertia when the screw comprressors start, can you offer me contactors power with 400vac or any cataluge to choose the contactors
How convergengr of nr method is not dependent on selection of slack bus and how gauss siedel method depends?
how to convert lv line to hv line and viseversa, any losses will occur during this process
explain different types of d.c motors?
can i use 2000/5A Clamp meter to measure HT cable
What is the formula for selecting the cabels according to load? How to calculate what sq.mm cabel to be used?
Is there any relevant technique to produce power from light and heat energy of the sun simultaneosly from same rays of light?
WHY DO VOLTAGE TRANSFORMERS FAIL DURING EARTH FAULT IN THE DELTA CONNECTED 6.6KV ELECTRICAL SYSTEM
In EHV transmission line a neutral grounding reactor is often placed at neutral point of shunt reactors. What is the recommended protection for this neutral grounding reactor? Should I use a fast closing switch to bypass neutral grounding reactor when this protection operates?
is it possible to say motor horsepower number without seeing name plate(when name plate damaged)