What is vector group? What is meant by DYN11?Why is it needed?
Answer Posted / rajiniganth
vector group is the symbol representation of phase
displacement between low voltage winding and high voltage
winding D-delta & Y-star connection which includes the
insulation level of the internal connections also
Is This Answer Correct ? | 2 Yes | 4 No |
Post New Answer View All Answers
Please explain the following and how these are working with PLC unit 1.I/O Module 2.I/O Device 3.Adaptor Card 4.Ribbon Adaptor 5.RS 485-FC
why swinburnes test cannot be performed on series machines?explain
how can you size an automatic voltage regulator?
if main CT is of ratio 50/5, and meter CT is -/5 what will be overall multiplying factor of meter.PT is 11000/110 .
Any Electrical Engineering jobs?Please refer for interviews. Thank you
what is mppt (maximum power point tracking ) and how they used in solar power generation ??? what are the main components used in mppt?????
why current is constant on d.c?
Define coil span?
what is the safe meggar values for motor, transformer HT, LT and Cables? IF we want to replace I/C bay at our 220 kv substation which is of 140 mw load capacity bay to be replaced by 400 mw capacity bay.other than CT(1200/1) what are the other equipment i have to replace. why we generally use 3.5 core cable or in other word 1/2 core for neutral and also confirm me that in balance conditiob(3 phase)current in neutral will zero
can any one provide me a connection wiring diagram for a DG set control panel along with BOM?
WHAT IS SUBSTATION & ACCORDING TO VOLTAGE HT,EHT SUBSTATION EXPLAIN IT
Safety of on line ups
When we have earthing mesh or underground earthing network in industrial plants, weather we have NT-S or NT-C-S kind of earthing system, so eventually weather we must use 4 or 5 wire in 400 volt level (For example 3×150+70 mm2 or 5×150 mm2) in this connection I would like to know exactly the paragraph of IEC or IEEE number
What are the section criteria for cables. Now everywhere XLPE power cable is used or PVC is also used?.
What should be the Sandwitch type Al. bus bar capacity for 2 M.W.Gen. set, having continuous full load current- 3463 Amps,ambient temp.- 50 Deg. C., Required temp. raise-20 deg.C., it will run 24 hrs, 365 days on full load, required highly reliable.