what is differnce between oil transformer & dry type
transformer ???????????
- 2 Answers
- 5471 Views
- I also Faced
- E-Mail Answers
Answer Posted / george
oil emersed xformer- uses oil for cooling system
dry type xformer uses only his housing for cooling system.
we call it heat sink
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
Write a note on Treatment for electric shock.
if any body have question paper of railway (section engineering),then plz send me .i will thank of him/her.
Why the power factor improvement is so important in industrial loads
1 “earthing” for bonding of equipment and circuits to common plant earth electrode potential, 2 “protective earthing (PE)” when this bonding is required for personal safety provisions 3 “grounding” for interference suppressing bonding of screens, sys-tems with ground level 4. low-impedance earthing ? 5.primary earthing system and secondary earthing system what is that? 6.earthing electrode or mesh net earthing electrode ? very confusing , simple but very informative help required ? i will be very very thankful to you guys.
When semiconductor fuse does save thyristor in each cycle of conduction? Why under voltage setting keep less in SPRS and more in DC drive?
How can calculate the rating of a servo stabilizer for given a specific load
In a voltage-controlled current source A A current booster is never used B The load is always floated C A stiff current source drives the load D The load current equals Isc
armature winding of dc machine produce alternating emf then it convert in to dc by using commutator.But only we consider armature resistance why don't we consider inductive reactane effect?
Whats the difference btwn a latch, port,data bus buffer? Do they all not hold data in d flip flops??
What is the function of capacitor in electrical circuits?
what is self capacitance of inductor
what irequirment need to be followed when working on live equipment
how can i find cable size from current rating?
What should be the values of settling time, peak time, steady state error, overshoot, rise time, MPOS (Maximum percent over shoot) to keep the system in transient state, to keep the system in steady state ?
In 11/0.414 KV Parralel supply network with Bus tie closed what will be the fault level is it doubled or halved??
