When a square wave is applied to primary of a transformer
then what will be output wave form of secondary ?
- 15 Answers
- 47611 Views
- Bhel, Sail, Sterling Telecom, TCS, I also Faced
- E-Mail Answers
Answer Posted / lotec
the output on the secondary will be altinating positive and
negative spikes corresponding to the rapid rise and fall
times of the square wave on the primary. you will get one
positive and one negative spike corresponding to the outside
edges of the square.
| Is This Answer Correct ? | 10 Yes | 1 No |
Post New Answer View All Answers
How much current will a 5 HP delta connected motor at no load will take?Is tat need a starter
What is transmittance?
When lag/lead/lag-lead compensation is employed?
What do you understand by oldham's coupling ?
A 100W electric lamp is supplied from a 115V, 60HZ source. The peak instantaneous power dissipated in the lamp filament is
how to measure earth resistance of a substation
What are the different types of hydro schemes?
Why does the speed regulating system adopting I controller have no steady-state error? In this single closed-loop speed regulating system, when the input of the I controller Un=0, what is the output voltage of the regulator? What factors do the output voltage depend on?
How to Calculate Current Rating of SDFU (Switch Disconnector Fuse unit) for Protectionof Capacitor Bank connected to Busbar of 800Amp,in LV side of 11/0.433KV, 250KVA Transformer?
How can we select suitable capacity generator for three phase load (inductive load) and how to take study analysis in 3 three phase load system ?
how to calculate IR value of 33KV cable ??
Hi everyone, I'm Lachuu, recently joined automation company as PLC Engineer. I have certain basic question, I request all big gurus and seniors to answer these question. Because this will be very helpful to me as well starters like me. How to design a control circuit (ex: pick & place - my current project) Yamaha robot PxYx series controller RCX222, using 6 cylinder double acting, plc keyence kv p16r 2 expansion unit for input and output each. How to select panel terminal mcb elcb powersupply. My main concern in some projects how to select dc power supply, mcb rcb(I came across dif bt b c d curves, but stil confusing, pls help me :-(. I would really appreciate all who are going respond to this question.
In case of salient pole alternator when number of poles are 4 or more than 4 it helps the flux wave to be sinusoid as air gap length is increased from center to tip , but if the number of poles are 2 how does the flux wave is sinusoidal?
What is the numerical quantity of sqcm?
In the N-series schneider reclosers. What is the difference between current during fault time and current at tripping? This appears in the Event log in an event of a trip out.
