Why we choose 400kv,220kv,132kv,66kv,33kv transmission
voltages for transmitting power. Why not other voltage
levels.
- 21 Answers
- 57114 Views
- College School Exams Tests, HC, HCL, Jaypee, JPMorgan Chase, I also Faced
- E-Mail Answers
Answer Posted / engineer
form factor is not the cause..else we would have 9.9 kv line system also...so nothing to do with dat..its all about the transmission system equipments,whih are designed for the voltage levels of 6.6,11,33,66,etc
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
sir i completed apprentice in TNEB.apprentice is eligible for 'c' licence
temp of cast resin 1500kva tx formerwent up to 138.c but came down very fast to about 100.c within 20 mins when load was reduced from 70% to 60%
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
How to calculat the ratio of HT\LT in energy meter
what is earthing.how we make it,describe briefly.
why we have to particulary use ACB for below ratings,even available of MCB,MCCB with that range ?
what will happen reduce the transformer voltage from 415v to 406v, is it save the energy,? are this methodis good to reduce the energy.?
what is the use of the puls transformer in UPS & how it works???????????
How to select cable the size, what is the parameters use and what is the formulas use for this cable size calculation?
derive DC RMS value for half wave rectifier?
armature winding of dc machine produce alternating emf then it convert in to dc by using commutator.But only we consider armature resistance why don't we consider inductive reactane effect?
if an insulated power and control cables of a running gas diesel gensets laid direct in an open trench i.e, trench bed is not rcc of a power house in which rain water, spillage water alwas exists and all power control cables remains submerged even when gas gensets of 480 kw each runningin on load. These power &control cables runs from power house to switchgear room through these trenches in which water remains most of the time. pl explain its merit & de-merit
which VFD is better ( LT or HT)
What is core CT & it's function?
can any one know is sbi interview based on merit or based on roll number
