Answer Posted / vinayak
The gapless metal oxide technique is used to achieve
non-linear characteristic.
In this technique Zinc Oxide grains with controlled
impurities of Bismuth Oxide and Antimony Oxide are
introduced to the resistor.
The micro-structure hence formed have execellent non linear
characteristic.
This technique is used in the formation of Lightening/Surge
Arrestor which are used in the protection.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
How to select a contactor? How many types of contactors are available
Can a generator runs after getting 1st stator earth fault.
what is ramping rate of generator
What is the de rating factor of cable? What is the importance of the de rating factor in cable select
explain the mode of metal iranafer in Co,welding
What OPGW is better than Microwave or PLCC???
What is the basic principle of operation of alternators/dc generators?
How much weight an electrical engine can pull??
What is the rating of circuit breaker needed for 300 KVA load in 33 KV supply line in a transformer of 33 KV / 415 Volt ?
WHERE NEUTRAL WIRE IS CONNECTED AT DOMESTIC TO TRANSMISSION LINE(SINGLE PHASE TO THREE PHASE)
sir i want previous entrance exam papers for written test
Why the efficiency of a three-phase induction is the motor is less than that of a three-phase transformer?
1)we have 1000 cfm Blower,Dia-1Mtr,Velocity of air 94 m/s 2)We have Natural Air velocity 94m/s 3If i Put Wind Mill in natural air ,speed is 94m/s Then it will generate Assume 100kw 4)If i put same wind mill across the Blower,air speed is same 94m/s now the Question is Will it generate 100 kw?
What is order of the system?
What should be the height of basement according to NBCC code?
