In order to ensure constant pressure and constant flow rate
of compressed air what should we put between the compressor
and end user?
- 10 Answers
- 27232 Views
- NTPC, I also Faced
- E-Mail Answers
Post New Answer View All Answers
2. Dry saturated steam at 3.5 bar is expanded through a convergent nozzle to 2.2 bar. The exit area is 5 sq. cm. Calculate the exit velocity and mass flow rate, assuming isentropic expansion and super saturated flow. b) A cast iron cylinder head is fastened to a cylinder of 750mm bore with 12 stud bolts. The maximum pressure inside the cylinder is 3 Mpa. The stiffness of part is thrice the stiffness of the bolt. What should be the initial tightening load so that the point is leak proof at maximum pressure? Also choose a suitable bolt for the above application 2 The propeller shaft of a marine engine is to transmit 600 kW at 1200 rpm, without a significant bending. The efficiency of the propeller is 88% at 32 knots ( 1 knot = 1085 km/hr). If the slenderness ratio is less than 50 and the permissible shear stress should not exceed 65 Mpa. Determine the diameter of shaft. 3 A semi-elliptic leaf spring consists of two extra full-length leaves and six graduated length leaves, including the master leaf. Each leaf is 7.2 mm thick and 65 mm wide. The centre-to-centre distance between the two eyes is 1.3m. The leaves are pre-stressed in such a way that when the load is maximum, stress induced in all leaves are equal to 380 N/mm sq. Determine the maximum force that the spring can withstand
Did elevation affect weight?
In which process internal energy remains constant ?
i have an iterview on 18 sep for bhel ,pls send some questions asked during interview during the earlier interview on 11th sep
What is the difference between Michell type bearing and anti friction bearing and the application.
Difference be betwin Fe-500 as per IS 226-1975 & IS 2062-2006
Is the unit and normal value fuel ratio of an average diesel engine?
What is a bearing?
What happened if the exhaust valve is leaking?
What is the formula for 1 HP of a two-cycle engine?
Which is the hardest material on earth?
Explain what is torque?
Name the sheet metal hand tools?
Give five differences between suction and discharge pipes?
How to decide the thickness of sheet metal while designing the bracket?
