Answer Posted / anwar mydeen
DCS is nothing but, Distributed control system. Nowadays most of the manufacturing or production plants are running with dcs.There is a central controller located in a system panel and the cotrol activities are distributed to each and every controller depend up on the process.
Due to the distribution of control, we can control the process efficiently.
Also we can connect third party interfaces like PLC and SCADA through serial communication links.
The DCS is introduced in mid 1970's by Honeywell and Yokagawa.
| Is This Answer Correct ? | 7 Yes | 0 No |
Post New Answer View All Answers
what are the use of belew gear in general ??
1. what is modbus cable? 2. what kind of communication we are using for the interface of DCS, ESD and Third party cabinets? 3. What is serial communication and peer to peer communication?
What is intrinsically safe system?
Explain operation of Haskel pump.
key exchanges in wpa,wpa2,tls
Can anyone send most commonly asked interview question in Oil & Gas industry
How we can check the 2 wire proxy switch? & how it is connected to DI MODULE OF PLC?
what is diffrance between FF & SMART, explain with difination
What is force balance principle?
How earthing can be checked????
Explain the difference between plc and cnc?
i have used level transmitter in starch cooking preparation tank. tank total height 2mtr.sometime LT display shows some error value when tank is fully empty and diaphragm side i already checked okay no problem in diaphragm area. field cable checked 24volt and mA shows correct value while tank empty mA is 4mA. 4mA i needed that 0% but display showing 10% or 15% percentage values are varying continously please give any good solution for me.....
wich is coming the first HAZOP OR SIL
can we copy the software from a transmitter using hht(hart 275) ?
how to calibrate corollaries (Mass flow meter)?
