what its mean 'inverter based technology' ? if we talk
about refrigerators, splits ACs etc how it helps to produce
& keep more coolness and chilled atmosphere ?
- 1 Answers
- 3578 Views
- I also Faced
- E-Mail Answers
Answer Posted / n.vijay kumar
Inverter based ac's are designed for low power consumption. in
conventional ac's when the set temperature is attained the
compressor will stop fully and only fan will run and again
when room temperature increase the compressor will start again
and runs till the desired set temperature. when compressor
stops and starts often it increases the power consumption,to
overcome this inverter ac's are introduced. in this type the
compressor motor is varied and hence controlling the speed of
the compressor there by stopping is prevented and compressor
runs at slow speed when room temp is reached.again when
temperature increases the compressor speed is increased. so
overall performance is good when compared with old type ac's.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is maximum power transfer theorem?
What are :- AC Distribution Board (Single & Double Front) DC Distribution Boards Distribution Board LT Breaker Panel.
what are the stresses in circuit breakers ?
What are motor generator sets and explain the different ways the motor generator set can be used ?
Difference between shunt, PMG and AREP excitation. Which is the most reliable between PMG and AREP.
how to introduce yourself
what is size of 3phase 4wire cable to be used for 11 ton ductable A.C and how to calculate cable size for different load
What is the difference between the relay and the circuit breaker?
what is 3rd Harmonics? how it is generated in alternator
armature winding of dc machine produce alternating emf then it convert in to dc by using commutator.But only we consider armature resistance why don't we consider inductive reactane effect?
what is high and low cut off voltage of BB and DG at SPS????????
When calculation of fault current and fault Kva is to be done,why always we use per unit value and why we consider the base kva?
We have 90mX100m hangar with 16 no.of supporting pillar. It is required to provide power supply on all pillars. what is suggested earthing scheme for hangars.
State kirchoff voltage law?
What is signal flow graph?
