difference between silent and non silent pole rotor?
- 3 Answers
- 12836 Views
- I also Faced
- E-Mail Answers
Answer Posted / ramesh behera
Silent pole rotor-
1)large in diameter small in axial length
2)where flux density are high so lows speed alternators are
used for generating electrical energy.
3)Arrangement of large pole such to max 64
4) so these type pole rotors are used in hydro-generator
Non-silent pole rotor-
1)small in diameter large in axial length
2)Flux density appx. low high speed alternator are used
generating electrical energy.
3)No pole field are less appx.=4
4)so these type pole rotors are used in turbo-generator
| Is This Answer Correct ? | 6 Yes | 2 No |
Post New Answer View All Answers
Why do we require transformer with less specific weight if supply frequency is increased?
what is EIB lighting control system? what is the advantages of this system?
diff. between tension mode & speed mode
During regenerative breaking= A rotating magnetic field is reversed B slip is positive C torque is positive D slip is negative
can we use CBCT in neutral of solidly grounded transformer? in place of three phases we can pass only one phase which decreases the size of CBCT?
What is resonant frequency?
What is the lifetime of a Thyristor? Is there a recommended lifetime for thyristors after which they should be replaced?
How to do fabrication , busbar and wiring cost for : 1. LT Panels 2. C& R Panel
is that any software calculator to calculate the size of cable
1.why should we connect the measuring instruments in l.v side in short circuit test of a transformer? 2.why the power factor is less in open circuit test of a transformer?
How does HT work & Voltage required?
Explain about Dubai electrical sysaem? Explain about Dubai drinking water system? Explain about Dubai Burj tallest building Electrical,Water.etc.. maintenance system?
How to synchoronize the generator (with gcb,GT) to grid????? ????? from Grid iam getting power (rated 400kv/20kv) through GT and its goes to UAT.,,ST.,, now my generator(rated 20kv ) ready.,, now iam closing my GCB.,, in GT iam suddenly giving 20kv on that Gt.,, what will happend
is there any device that works properly accept relay, it may be fuse but if i want fuse of 33kv 300 amp it is avaliable, pls give me details
HOW CAN I GET 5CORE HO7 CABLE SIZE IF I HAVE 1800A?
