Answer Posted / guest
concrete precast bridgres are the best type
| Is This Answer Correct ? | 3 Yes | 4 No |
Post New Answer View All Answers
How is the leaning tower of pisa supported?
What is the value of live load that should be incorporated in design of locker room and cash vault room while designing a building for commercial bank?
What is Critical path in Ms-Project ?
For removal of formwork of simply supported slab / beam from where to start the deshuttering? ( Max Bending moment of the simply supported beam is in the center hence is it required to start from the supports?)
manhole height is 1500 mm and width of brickwork is 230 mm dia of manhole covering is 560 mm brick masonry 1:4 horizontal length is 1500 mm and plaster 12 mm thick on both side 1:3. how to estimate the quantity of brickwork with mortar cement and sand for manhole chamber.
what is the difference between replacement of cement by groundnut shell ash
1. For 10sq.m area(47 kg bitumen contain) of 45 mm thick bitumen mix layer..how much bitumen is required for 1600 sq.m and how much aggregate need for that ?? 2. And much tonnage of bitumen mix required for 10 sq.m area of 45 mm thick. Please give answer...
How much river sand contain the 6 & 10 wheeler truck? Or Maximum sand that any type of truck carry?
What is difference between code and standard and specification?
How to calculate cement and river sand material Qty for waterproofing base coat and finish coat
For the calculation of bearing pressure below the footing, to know whether it is below the safe bearing pressure of the soil, the unit of RCC below ground level to be taken is 25 KN/m3 or (25-15)KN/m3, where 25 is the unit weight of RCC and 15 is the unit weight of soil and whether the weight of backfilling to be taken?
A 16 pile group, consisting of diameter concrete piles, were cast in situ in a clayey soil whose unconfined compressive strength is 1100 psf. Each pile is 60 ft long and the pile spacing is 2.5 times the pile diameter.The water table is at the ground surface and saturated unit weight of the clay is 118 lb/cu.ft. using a factor of safety 3 and a reduction factor =0.45, compute the allowable capacity of the piles acting as individuals
In few lines, please be elaborative on extras and talents that make you a potential candidate for the post:
What is a projection line?
Define What is unit weight of normal concrete?
