Answer Posted / mohsin jamil
because motors start slowly with high torque and bcz of high
torque it needs high amp until it reaches to its full speed..
thats why we use Star connection or start the motor slow so
that motors winding doesn't burn
| Is This Answer Correct ? | 6 Yes | 2 No |
Post New Answer View All Answers
Sir, plz tell me how droop setting is done in parellel operation od DG set ? please give practical example ?
how to estimate wiring ins roughing ins. and boxes
How to calculate total harmonic distortion level(THD) in VFD? and how can we reduce harmonics?
how can see the ac indoor or out door ac which Tr
if we apply 1000ADC instead of 100ADC or We apply 50ADC instead of 100ADC,What will be happened in the test result value.Pl explain
in a silicon diode we can measure .7v in a voltmeter.but why we can't use this voltage for using?
design a 3 bit synchronous and asynchronous counter using T- flipflop
how to calculate current and voltage in a same circuit?
Is a 300w induction motor used in a food processor as powerful as a 1000w DC motor.
A 2083kva AVR was tested, phase to ground shows continuity, what is the implications
Please help me regarding my one concern. - During earth pit testing we noticed that the Clean earth pit and dirty earth pit showing continuity (Resistance value - 5ohm) . I want to know that if both earth pit have separate location and there is not internal looping between PIT then why such continuity is showing on it . Because of this issue the field side all earthing point showing short. In PLC panel we are providing two types of earthing cable which is coming from separate earth pit (Clean and Dirty earth pit) because of earth PIT showing short our PLC is not complying spec . please help regarding this issues.
In a power conditoining unit (inverter) of a solar plant when we measure the d.c. current fed by different strings of solar plates to inverter, the current in the negative wire is less almost by 1 ampere to the current in its positive wire say current in positive wire 5 A , then current in negative wire of the same string is 4 A. Since the current entering should be equal to current leaving then why the current is noticably less in negative wire.
what is meant by brushed alternator & its working principle ?
how braking & making capacity of circuit breaker is calculated?
why we dont prefer ac voltage controller instead dimmerstat [if both have same rating] for conducting experiments in laboratories?
