WHY WE WILL USE 0-24VdC IN ELECTRONIC CIRCUITS AND
INSTRUMENTATION TRANSMITTERS?
- 3 Answers
- 11052 Views
- Aban Power, Jindal, JSW, Sugar Factory, I also Faced
- E-Mail Answers
Answer Posted / naveen rai
it is standard value followed all over the world..
| Is This Answer Correct ? | 4 Yes | 3 No |
Post New Answer View All Answers
What are different types of orifice plates? State their uses.
In power plant to measure vibration of a turbine we install sensors. Before install this sensor we have to set gap voltage. What is meant by gap voltage and its use?
why use 50% lel methane gas concentration for gas detector calibration instead of 60% lel gas concentration whereas the hi alarm set at 60% lel.
when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?
why we use cascade control and feed forward control in 3 element drum level control measurement of steam drum .what is cascade and feed forward control system ?give example .
what is the difference between -24 : +24 & 0:24 and where it use?
What you mean by multi stage control vavles?
what is interface level measurement.who can calibrate interface level measurement transmitter online
we want to control pump in let pressure and tank (for exp) our inlet line if water cam and pump will on and when our tank will full pump will off also if our inlet pressure low pump will off even tank not full.this pump i want to uses on our water supply line.
Do you have reference list?
Why all the drains(Gland sealing,ESV,Casing inlet etc) are directly connected to the flash tank instead of hotwell of the condensor in the power plant? My Email Id:naba02222@gmail.com
why Fahrenheit unit of moistur analyzer transmitter
HOW CREATED LP & HP PRESURES IN DRUM FOR DRUM LEVEL MEASUREMENT!
Can combine control system for Emergency control system (ESD)and Fire & Gas System ( F & G) is possble to built and offer to client? Can such system is as per Norms in India?
䑰ҕ䔈ҕ䖠ҕ䘰ҕ䛀ҕ䝐ҕ䟐ҕ䢐ҕ䥐ҕŹ
