Why the Motor takes High Current in Starting time?
- 5 Answers
- 10615 Views
- I also Faced
- E-Mail Answers
Answer Posted / chreamz
During starting time, the motor acts like a blocked rotor.
The flux created on the armature turn to oppose that of the
rotor. Hence the motor amperage rises far beyond the
rating. It's estimated that, during starting time of the
motor, Operating Current = 6 times Norminal Current.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
fuel-air ratio in a petrol engine fitted with suction carburettor,operating with dirty air filter as compared to clean filter will be
3Cx240 & 3Cx300 sqmm Al. cable from lv side. What is the calculation for this cable??
why Lightning arrestor are made by 2 seperate stack of inslutor but why cvt are in single stack of insulator.
what should be the acceptrd value of winding resistance for 2.5MVA transformer
Give some differences between open loop and closed loop?
what is ratio of copper wire size and current ?
how we can set the IDMT relay.
can i use the six sigma method which is used in management area, in state estimation of power systems?
what is R Core Transformer. how it differs from normal transformers. dont search in net and post the answer.
What is the need of generator relay panel
what is the difference between fault current ant short circuit current?
what is level 2 automation?
What are safety device in vcb and acb?
Explain bypass capacitor?
What is the principle of HIGH SPEED DIRECT DRIVE MOTOR ?
