How much is the starting current for HPMV lamps. How many
lamps can u wire in a circuit
- 1 Answers
- 5030 Views
- Technip, I also Faced
- E-Mail Answers
Answer Posted / hassan
I start=10 * In
for example
500 W HPMV lamp In =2.08 A & Istart=21 A
How many lamps ....?
This depends on the wire surface.
2.5 mm2 >>> 6 lamps
1.5 mm2 >>>> 4 lamps
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
Draw a SLD of HT distribution EB grid up to users Transformer?
why does connected a indutor with mnsformeretering core of current transformer ?
what are the necessary basic electrical topics to learn for mechanical engineer to deal practical problems.
witch pump used in wtp
hi frds, i m electrical engineer.can i get cdr for electrical engineer if u have then send me on my mail id its jayesh_ee88@yahoo.com.please help me frds
Draw a circuit diagram in which if button is open we can use socket and bulb as a series test circit and if button is close than simple we can use socket as any load purpose.
Power factor =1.000 at factory in supply. However, PF = 0.8 at motor end. Current = 100 Amp, Voltage = 400 V. What is the power distribution loss? Can I reduce it by adding capacitor at the load feeder?
show the single line diagram of star delta starter with single phase preventer
Hello Guys !! i want to rrb section engineer electrical(signal) previous model papers? any body help me?
WHAT IS THE FUNCTION OF SHORT CIRCUIT MAINTENANCE CT
what are the protecyion of transformer & generators
temp of cast resin 1500kva tx formerwent up to 138.c but came down very fast to about 100.c within 20 mins when load was reduced from 70% to 60%
kindly send me 11KV MV motor differential protection procedure by primary injection method.
how is the incoming cable size calculated for a given current rating of a panel??
How is magnetic leakage reduced?
