Answer Posted / ashok mishra
earthing is connected to earth
earthing is at zero potential and its just for saftey of equipment and operator
nutral is the central point of star connection and used to complete the circuit
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
how to select the mpcbs and contactor for 3 phase 30 hp star delta motors.for plc control.and tell me the calaculation for future use.
In a carnot engine with an efficiency of 40%, the heat rejected to the sink at 27 C is 60 kJ, then the heat supplied in kJ to the engine by the sources is
Phase control and integral control are used for?
Explain Continuous and Discrete signals?
What is the de rating factor of cable? What is the importance of the de rating factor in cable selection?
What is ignition module of a CAT Gas Genset G-3508 Engine, Alternator SR4B Series. HOw its checked for correct functioning.Is it repiarable or replacable?
How to Design green buildings services? What is the advantage to design green building?
please send me jindal previous aptitude and technical question and answer.my email id is deep_raj@live.com
why +24 v and -48 v give to BTS? If -48v protect from surge then why we not use -24 v?
what are the ''pitting rings''and how cn they be controlled in a series generator
How we can defined theecopper cable size if we know the aluminium cable size?
plz tel me syllabus and exam date 4 jr executive engg (electrical)
temp of cast resin 1500kva tx formerwent up to 138.c but came down very fast to about 100.c within 20 mins when load was reduced from 70% to 60%
difference bewteen reverse current and alternating current
how much value of resistance should connect to 15 kw, 6 pole 3 phase slip ring induction motor having RV-240, RA-42.
