Answer Posted / sujeet pandey
we use permanent split capacitor single phase induction motor.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
in a silicon diode we can measure .7v in a voltmeter.but why we can't use this voltage for using?
How the frame size of a flange mounted AC induction motor is calculated?
11 kV line deraction check by an Engineer.
Why the power generated in dams is complex power? Why the generators in dams cannot produce Real power directly (i.e power which has zero reactive part)?
Both generator parallel condition shared load equally but one genrator taking ampere more than the other what are all the causes to make like this
what is meant by residual over voltage & residual earth fault ?
how to calculte capacitor range for single phase induction motors??pls tel
How do we calculate the Out put voltage of generator, after the excitation is being given?
the typical output of a solar cell is........
how much maximum load a 2 core (Single phase) 16mm aluminium wire can take ?
What are the basic properties of signal flow graph?
What is safety of Ht panel
How to megger test 11 kV cable and the acceptance IR value
what are inherent currents?
Hi Friend I am used multimeter to measure the voltage between R Phase(SS1) to R Phase(SS2). In SS1 is connected with UPS loads. But I am getting voltage between these 2 R Phases. Please give some idea friend
