Interested to Buy Any Domain ? << Click Here >> for more details...
Define Current Transformer?
Working & TYpe's Of C.T.
- 4 Answers
- 7133 Views
- I also Faced
- E-Mail Answers
Answer Posted / bhadrappa
it is a device which works on the principle of mutual
induction.
it consists of two windings with thick copper windings of
perticular ratio. primary winding is connected in series
with load to carry load current and it is induced in
secondory is connected with a appropriate meter to measure
load current.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
What is the difference between acs 550 & acs 850
hi I have done 3 yrs diploma in electrical engg after 10+2. I have 16 years of work experience into design proposals sales and engg application development in LV/MV swithcgear and sub station automation field. I want to apply for immigration to new zealand but I am not sure whether I qualify or not since I dont have a degree. Can anyone advice? Thanks Riz
Consider three heater bank connected in 3 phase star with neutral.Each heater bank connected in each phase.So each phase get 230 volts supply.my question is,during balance condition, current flow in neutral or Not
wat system call?
in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com
What will be the diameter of pipe between conservation tank and transformer
The synchronous machine excitation system explain
In what cases (circumstances)we should apply P controller, PD controller, PI controller & PID controller ?
what is a bus riser in power system and why it is used
HOW TO CALCULATE HV CABLE SIZING?
Wind mill
Explain the operation principle, advantages and disadvantages of the following converters: a) A 12 pulse converter b) A Switch-mode inverter c) A thyristor inverter
what is the solution for meger test failed the MV cable?
What is meant by bus bar protection?
What is a dominant pole?
