Interested to Buy Any Domain ? << Click Here >> for more details...
what is mean by bulking of sand?
- 11 Answers
- 53220 Views
- CCCL, Kanakia Group, I also Faced
- E-Mail Answers
Answer Posted / ladheedha
When mixes are specified by volume, the sand is assumed to be dry. The volume of a given weight of sand, however, varies according to its moisture content. Equal weights of dry and inundated sand have practically the same volume but the same weight of sand in a damp condition can occupy a volume as much as 40% greater. This phenomenon is known as 'bulking'.
| Is This Answer Correct ? | 25 Yes | 4 No |
Post New Answer View All Answers
how to calculate the weight of concrete
Dear sir, i want to NBCC & NTPC previous exam papers email Id : madhu_bingi@yahoo.co.in
In foundation design, while we do the base pressure check, we normally check if the attained pressure value is less than the GROSS BEARING CAPACITY of the soil which is the sum of net bearing capacity of soil and the overburden pressure. Actually, the overburden pressure acts against the net bearing capacity of the soil and I feel that we are actually increasing the bearing capacity value and doing the check. I feel that this is NOT right. Please clarify on this.
do we consider shrinkage factor for calculating cement consumption for CM mixes for different works?
Slab quantity
5. Two long boundary walls run parallel to each other at a center to center distance of 1 meter apart. The width and height of the first wall are 0.30 m and 2.5m respectively. While those of the second are respectively 0.18m and 3.5m. Plot the distribution of vertical stress intensity due to walls on a horizontal plane, 1m below ground level. The walls have negligible depth of foundation and are made of brick masonry (y = 19.2 kN/m cu)
we want build 10ft height ,tostore 4 litresof water.what is theground basement for steel andcement andsand.please send us basment calculation?
How we calculate the service time of buildings
What is the difference between tor steel and tmt steel?
What is 1/8 on the architect ruler denotes?
Advantage of Aluminum form work in terms of activities can be skip and cost too
in plate load test what is the thickness of plate 20mm 5mm 50mm none
what is idealized curve for concrere and steel
What is the cost difference between site mix and ready mix concrete per cubic meter
what is the composition of good brick ?
