Interested to Buy Any Domain ? << Click Here >> for more details...
Whats maxi. slump of M-7.5 Concreit for PCC
- 2 Answers
- 8372 Views
- Indiabulls, Swastik Group, I also Faced
- E-Mail Answers
Answer Posted / kuldeepkumar
50mm
| Is This Answer Correct ? | 10 Yes | 0 No |
Post New Answer View All Answers
What is a hatch patterns?
1. What is coefficient use for calculation of shuttering. 2. What is coefficient use for calculation of reinforcement in one cum of concrete.
Can anyone tell me the sequence of the activities in a drawing room, kitchen & Toilet including civil work, finishing, electrical & plumbing fittings
How many hours should traffic be not allowed after completing wbm road or bst.and min how many hours should road rollers be used.
A doubly reinforced concrete beam is 25 cm wide and 50cm deep to the centre of tension reinforcement. The centre of compression is steel is 5cm from the compression edge. The areas of the compression and the tension steel are 10.16cm2 and 12.56 cm2 if m=18 and the bending moment at the section is 7,000,000 N-cm. Calculate the stress in concrete and steel.
For plate load test why we are applying pressure 3 times the proposed allowable bearing pressure? Is there any supporting standards for this?
HOW TO CLACULATE CEMENT AND SAND CONSUMPTION FOR THE STAIRCASE KOTA FLOORING IN THE RATIO OF 1:4 50 MM THICKNESS
What should be the lap length in raft if height of raft is 0.800mm ...it couldn't b 50D or 40D...we just have to join upper and bottom reinforced...is there any formula for determine it...
In jack arch floor, the rise is kept?
How can we make a hole in a solid rectangle using solidsworks?
What are the basic use of runners and standards of pipelines?
What is passive earth pressure ?
How to determine thee cut length for steel reinforcement bars in R.C.C design
Define What happens to Load at yielding ?
by which materials we can prepare circular shuttering with tentative cost of material(rate analysis)
