Answer Posted / parmod kumar
It is a static device which is working on the principle of
electrocmagnetic induction and transfer voltage from one
level to another level without change in frequency i.e
frequency remain same in primary as well as secondary.
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
IF TVM OF TRANSFORMER SHOWS POWER FACTOR ON 33 KV SIDE AS 0.97 LAGGING AND ON 132 KV SIDE IS 0.75 LEADING.IS THIS CORRECT.WHERE IS PROBLEM.
We are preparing another project which involves Waste heat recovery from a 1 MW GE Engine. The Engine in particular gives out flue gas at 487Deg C with a flow rate of 5650 kg/hour and this can be cooled to 180 Deg C. This gives a thermal output of ~ 594 KW that is available for input to VAM via heat exchanger / boiler. Additionally 581 KW will be available from engine jacket water (temperature profile 80/ 80 Deg C and a flow rate of 50m3/hr) Our estimation is that 300 TR of cooling is possible with a suitable VAM machine(s). Please advise what is the most suitable arrangement with maximum TR and min Capital expenditure. plz reply me as early as possible
how freewheeling diode improves the powerfactor
What is the minimum value of hfe for the oscillations in transistorized rc phase shift oscillator?
we have earthmat at 110KV substation.we would like to take earth resistance.b some says that by connecting earth megger terminals (C1,P1) at middile point of earthmat (at riser) will cause voltage gradient at other earthmat nods and dont get exat earth resistance.when connecting at end nods will get exat value . is it correct .please explain
what are the values of VRY,VYB,VBR,Vry,Vyb,Vbr,Vrn,Vyn,Vbn for Magenetic balance test of 100 KVA and 63 KVA Distribution transformer
State and define norton’s theorem?
How many VSC based HVDC are there in India and the world
block diagram of 2 ups system connected in hot stand by mode?
which is the best institute for PLC,SCADA,DCS in hyderabad
how we sesign the transformer give some specifion regarding design of transformers
What should be the height of basement according to NBCC code?
what is advertised hop count
hi, i finished b.tech eee in 2008, im worked in dg sets mfg company , now i left job in 6months back, now again i want get job core side, how can i get? is there any couses we have learn to get better oppurtunity? /
What is knee point voltage of transformer?
