What is Primary and Secondary Injection Test of CT and
Relay.
- 2 Answers
- 20365 Views
- I also Faced
- E-Mail Answers
Answer Posted / roy
primary injuction means we will inject the current in the
primary of the current transformer. and according to the CT
ratio and relay setting the relay will operate.
secondary injuction means we will disconnect the wires from
the secondary side of the CT and inject the current to the
relay directly. the relay will operate according to its
threshold.
| Is This Answer Correct ? | 23 Yes | 5 No |
Post New Answer View All Answers
what percent do you derate your copper wire when you change from copper buss to copper wire
In general bus riser follows the bus section in SWGR. What are impacts if bus section follows bus riser?
In AC if the direction of current keeps reversing every half cycle, how does it propogate through the transmission lines?
we have require a Motor (1500kW, 6.6kV, 50Hz) which shall operate at 1500rpm during 30min and after it shall run on 500rpm during 15min. The same cycle shall be repetitive during the whole working days. Which method is best and economic to achieve such type of task. VFD, VVFD, Pole changing motor etc.
Write down the name of 2 lady Bir Pratin of Bangladesh
what is the differencce inn series and cascade connection??
why did youi choose this career?
What is a copper loss or i2r loss pc?
which type of effect of turbine and generator reverse power protection ?
what is frequency response?
WHAT IS START TO INDUCTION MOTER IN STAR TO DELTA OF >5HP ?
State superposition theorem?
A 11KV, 1200 A breaker combination fixed in a cubicle for HT motor.Is normally for 11 KV motor fuse is using? if Yes, What range fuse is required?
What is maximum power transfer theorem?
how synchronous condenser is used in place of synchronous generator with out negotiating IEEE standards? Can i use 3 generators as synchronous generators and 2 generators as a synchronous condensers in an IEEE 14 bus system with out disturbing the standards?
