Answer Posted / shahnawaz
We use Lap in construction work with TMT bars mostly we use
50xd,40xd etc. but we can not decide infect its totally
depend on Design of the building.
| Is This Answer Correct ? | 7 Yes | 2 No |
Post New Answer View All Answers
how to determine H- zone in a column? where it will occur?
how to caluclate sienerge qty in construction in ap
What is passive earth pressure ?
what is idealized curve for concrere and steel
material used for mendrel use to bend epoxy coated rebar
can i make bricks using M10 grade concrete ? and what would be the cost of a brick if we use m10 grade concrete sand and aggregates ??
what will be density of a cement bag if its weight and volume are 50kg and 1.25 cft respectively???????
I used Etabs software to analyse a high-rise building. And I want to use templated UBC-codes inside to calculate the Seismic load. My question is: whether or not I have to control the seismic load by base shear load which is manual calculation? (just for more clarification: I can control this by input the scale factor into Eartquake definition in Etabs) I would highly appreciate your answer.
CAST EFFECTIVE WATER SUMP CONSTRUCTION DETAIL
How did the romans get water up hills using aqua ducts?
how to calculate MR 9(derivation)
I need model question papers for writing the Dubai municipality exam,for G+1
in staad pro. modelling for a parallel scissors chord truss, when i assigned roller support i.e fixwd but with all Fx, FZ, Mx, My and Mz release except Fy... the analysis results " in stability at a joint, with direction Mx or My..what could be the reason...anyone please explaing
How many square meter can mason layout chb per hour
What are the techniques to measure road difference?
