I've descovered that when the earth wire in a domestic
electrical installation is not connected back to the board
(ground) a voltage of between 9-24v is is found to be
present in the earth wire.
When connected at the board there is no voltage - is this
normal and why does it happen?
Post New Answer View All Answers
The screw thread commonly used for transmission of motion is one of the following types of threads
What kinds of decision are made about CT from it's Knee point(voltage & current)?
How can find thermal state value in relay for calculate thermal overload.
How to address the servo drive for motor
Advantages/Disadvantages of earthing of neutral bus on MSB instead of separate neutral earthing for transformer/DG sets feeding to MSB
what is the effect of change in supply frequency on load angle of synchronous motor,all other parameters remaining same?
3Cx240 & 3Cx300 sqmm Al. cable from lv side. What is the calculation for this cable??
What is FM200 Gas??Applications........
A 3-phase IM is supplied from 50 Hz system. It runs at speed of 1440 rpm and slip equal to 4 %. Calculate number of pole pairs. A 1 B 6 C 2 D 3
what will happen if earth of 33 kv cable (earthed system) is not connected to earthing pit?
for 750 kw LT load what will be the ht kva
how we control automatic generator i'e with to supply (main supply and local generator) when the main supply was break to supply the local supply automatically to begin supplying power.I now this control circuit is the combination of contactor time delay contactor switch and overload relay .but my question is how we combine those component thank you
can you send me the placement papers of electrical engg. from companis like NTPC,DRDO,IOCL,HPCL,BPCL etc.?If,plz send as soon as possible.Thanks.
how to Select its CORE in electrical cables based on its applications? or Application of various types of electrical cable based on it CORE?
how to calculate the change over time for star delta starter for different KW motor?