In a Tap changing transformer where is the tap connected ,
is it connected in the primary side or it is connected in
secondary side
- 8 Answers
- 18085 Views
- Indiabulls, I also Faced
- E-Mail Answers
Answer Posted / a.p.nanjappa
Tap changing are always provided in HV SIDE OF TRANSFORMERS
AS CURRENT IS LOW.
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
why don't we use the generator as a motor? and what will happen?
What are the advantages of hydropower?
What are the basic components of the feedback control system?
Connection diagram for KW meter and Kva meter
ow can i get certificate of competency as electrical supervisor and my diploma in electrical engineering from jalgaon.
What is a parabolic signal?
what are the 4 rules to start the motor?
Why do power lines not short out when they fall into water?
If we need 4c× 50mm sq cable but it's not available so we can pull 4c×25mm sq two cables?
we have provided 30 nos. relay contacts in panel.I want to know how do we do the numbering for the relay contacts as per any applicable standards
what is the working process of over & under voltage relay.
How to determine alternating current frequency?
how to know the diffrential relay setting of 06mva step- down (delta-star)transformer?
What are the factors influence the choice of an electrc drive?
salam&hi, i need to know about how can i calculate an enough current for the new building before i submit it to the suppliers
