We have a 62.5 KVA DG with Leyland engine and kirloskar
slipring alternator. We have earthed the neutral, and another
earthing for the dg body. is it necessary to isolate the dg
foundation with rubber pads?
- 1 Answers
- 3315 Views
- I also Faced
- E-Mail Answers
Answer Posted / a.p.nanjappa
As your DG is a small capacity,it is okFor large DG ,dg
founations are earthed. rubber pads reduce the vibrations.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
what kinds of Transformer oil grade is better for power transformer ?
Help need in transformer !? Hello Friends The parameters of 2300/230 v 50hz t/f is R1=0.286 ohm R`2=0.319 ohm Rc=240 ohm X1=0.73 ohm X`2=0.73 ohm Xm=49.2 ohm Secondary Load impedance ZL=0.387+J0.29 solve the exact equivalent circuit with normal voltage across primery.. I know every thing but i cant find CURRENT I1=? and I`2=? Please help me give solution or only Formula please please...
define digital electronic
I use 20 nos led tube 4feet, in pathway 100mtr approximate, so what size cable i use for lighting
How do you determine the size of transformer radiators in a transformer?
what is quality factor in series resonance circuit and calculate the factor of voltage magnification? how it happens?
kindly send me 11KV MV motor differential protection procedure by primary injection method.
what is cathodic protection and why it use in industries?
plz send me HPCL apptitude paper.. maulik_elect@yahoo.co.in
How many gap between finger contact in a.c.b. and v.cb.?
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
What is icu and ics in Acb and how many time icu or ics passes from breaker?
Distribution transformer we provided 2 separate earthing pit for Body and 2 separate earthing pit for neutral,we can not connect separate body earthing pit to other earthing pit but we do metal glanding in secondary side cable termination in both side, transformer and PCC panel (LT Panel), is this safe for transformer and other equipment?
Why does increasing the magnetic flux in the main field of a d.c motor cause the armature current to reduce??
what is a bus riser in power system and why it is used
