If I want to lab 16 mm dia. bar with 20 mm dia bar with 40D
lap length which dia.should I consider for lapping
- 12 Answers
- 50704 Views
- I also Faced
- E-Mail Answers
Answer Posted / nil ratan adhya
20 mm
| Is This Answer Correct ? | 8 Yes | 8 No |
Post New Answer View All Answers
which red: used in roof teping, then use only cement
how much quantity of 1.5" nails and 2.5" nails are required for conventional formwork shuttering?
What do you mean by the word 'shear'?
Can anyone tell me the sequence of the activities in a drawing room, kitchen & Toilet including civil work, finishing, electrical & plumbing fittings
roll of DLC in road constructions
Which tests are performed on soil to decide the type of foundation to be provided.
is there any influence of water(used for mixing of concrete) on a weight of harndend concrete.
What is the use of extend command?
cud any one send me tech quest paper(civil engg) at tarizus@yahoo.com
What is meant by Crystal Concrete?
For removal of formwork of simply supported slab / beam from where to start the deshuttering? ( Max Bending moment of the simply supported beam is in the center hence is it required to start from the supports?)
Does brick grows bigger every year?
What is the different type of slump test indications?
57. Calculate the volume of a truck loaded with stone chips whose data are as follows– 5 Top Length - 13-9, 13-10, 13-09 Bottom Length - 13-11, 13-10.5, 13-10 Top width - 8-7.5, 8-8, 8-7 Bottom width - 8-7, 8-8, 8-7.5 Depth - 2-0, 1-11.5, 1-10, 1-11, 1 -10.5, 1-11.75, 1-11
how to decide the mortar ratio 1:4,1:6 in masonry? same in plaster 1:3 and 1:4? which code or any document reference taken to define proportion?
