i have height of stem drum level 1000mm.how i calculate the
DP transmitter
- 2 Answers
- 8422 Views
- I also Faced
- E-Mail Answers
Answer Posted / rajesh
firstly select dp transmitter .connect one port to level pipe . and one exposed to air . so it becomes atm air to pressure inside the steam drum . now after placing , calibrate it with level and now the transmitter will give direct reading of level .
| Is This Answer Correct ? | 0 Yes | 7 No |
Post New Answer View All Answers
Where Can i take a SPI INtools training in Mumbai? In Rolta India Ltd to whom I should approach regarding of SPI INtools Training?
What are the application of bernoulli’s theorem?
IS there any effect of vortex in low pressure side of the transmiter after the orific in feed water line? if yes then what is the calculation?
Why MUX JB's are using only Temperature Element in Fundation field bus?
In which principles tx ,pressure gauge,Temp gauge,control valve works?
how to calibrate load cell
Decibel.
What is standard of DCS panel design?and what is step of DCS panel design?wiring and type of connector(screw or DB connector)
How to calibrate Field bus transmitter? procedure ?
Explain about the leakage class of the control valves
what is the importance of CV in the control valves? how it is calculated?
Why do we have earthing cable in branch cable and shield in the same cable?
What is 3 element control system
Why flow/pressure transmitter before control valve?
Difference between dcs and plc including date processing and architecture.
