In a Tap changing transformer where is the tap connected ,
is it connected in the primary side or it is connected in
secondary side
- 8 Answers
- 18086 Views
- Indiabulls, I also Faced
- E-Mail Answers
Answer Posted / vishnu vardhan singh thakur
its on secondary side. if it is placed on primary side and
when the voltage is increased magnetic core will be saturated
and if the voltage is reduced the magnetic core is not fully
used...... and mostly tappings are provided on HV side because
the current on HV side is less where it is high on LT side. so
when short circuit occurs no damage will happen thats y
tappins are provided on HT side
| Is This Answer Correct ? | 1 Yes | 3 No |
Post New Answer View All Answers
advantage of motor design on higher power factor . normally motors are designed for .8 power factor. what is advantage of designing at .88 power factor
how to determine motor size for a fan application?
calculate external resistance values to add to the rotor of a slip ring induction motor. STATOR- 415 V, 3 phase delta, 1100 A, 50 Hz, 1490 rpm, pf 0,86 ROTOR - 660 V, 590 A, 50 Hz. STATOR current at each steps STEP1-600A,STEP2- 800A,STEP3-1000A,STEP4-1100A.
Is potential difference materials property ..? if yes tnen how.. explain brifly.
What is difference is of VSD,VFD,VSDS, are they the same as the direct current to control dc using above mention
Two electric lamps 40 W, 220 V each are connected in series across 220 V. What is the power consumed by the connection?
area control error
please send me latest & previous years question papers for IOCL Technical level questions
How can we calculate ac current from the given DC current when AC voltage is given?
Difference between megger test equipment and contact resistance meter test instruments?
Is it possible to measure the voltage of a battery from a single terminal?
if 6 earth pit value is 1.5 ohm then what should be the number of earth pit to make the value .8 ohm
The Q-facr o of a coil given as wL/R. what will be shape of Q versus frequency graph.
What are steps to be taken while designing of DYN11 distribution transformer to achieve magnetising balance?
what is meant by power and distribution transformer ?
