In a Tap changing transformer where is the tap connected ,
is it connected in the primary side or it is connected in
secondary side
Answer Posted / suryaraj
Tapings are
connected to high
voltage winding
side, because of
low current. If we
connect tappings to
low voltage side,
sparks will produce
while tap changing
operation due to
high current. Not
depend on primary
or secondary.
| Is This Answer Correct ? | 39 Yes | 0 No |
Post New Answer View All Answers
Is single load(eg: three phase motor) having all the components like positive,negative,zero sequence components during fault condition?
How to calculate Air conditioning capacity for a telecom BTS shelter?
Explain the advantages and disadvantages of hydropower plant?
What is the minimum IR value of HT/ LT cable? Pls post separetely!!!!!
How isolater function when installed inelectrical 440V wiring
How PSV sizing being done
234 MVA Generator 3 phase Short circuit current Values required? Gen set Rating-234 MVA, Gen Voltage-18kv, PF;0.8, Xdv:23.5 %, Transformer Rating-18/380KV, 680MVA,Yndd1 two winding, Step up TR, ZT:35.50 %,X/R 4.33 Gen CB Position, CB open ,Disconnected open, Generator Running Voltage 18 Kv, Bi mistakes generator side earth switch Closed during that time short circuit current level in 3 Phase required, and how to test on site 234MVA Generator Short circuit current,
How do we calculate the Out put voltage of generator, after the excitation is being given?
Why insulation level follows this order? transformer < bus bar < circuit breaker & Isolator < transmission line.
what are the range of memory address in plc for L&T lx7 4A
What is the difference between a verilog task and a verilog function?
role of europe union in UK safety legistlation (electrical safety)
Is it possible to measure the voltage of a battery from a single terminal?
What is the Nyquist criterion regarding control systems?
Why we use ups battery and dsdb battery in thermal power plant