can we measure +,-.zero sequence current ....?
if so how can ???
Answer Posted / k.prakashchandra
The measurements can be done by electronic devices by
feeding the formulas
Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
some time we open engine breaker 8.0 MW load but plant not trip. and another time engine open 4.0 MW load engine trip why? individually engine breaker open & individually emergency stop why difference?
Plz tell me how we can find that particular company has vacancy or not
What is difference between isolator and circuit breaker?
A 2083kva AVR was tested, phase to ground shows continuity, what is the implications
before synchronizing an alternator,power factor is leading ,why?
Is it possible to make a 5P10/ CT Ratio 50/1A Burden 5VA
What is the difference between rulling span and wind span of of an Over Head Transmission Line?
how much cable size required for 70 kilowatt load.
WHY EARTHING NOT NEEDED IN BATTERY IN SUBSTATION
Why does the speed regulating system adopting I controller have no steady-state error? In this single closed-loop speed regulating system, when the input of the I controller Un=0, what is the output voltage of the regulator? What factors do the output voltage depend on?
what are the available sizes of pin type terminal lugs in the market today?
what is the main parts of transformer? how it is functioning? pls giv the ans briefly.
1.What is captive power plant? 2.What is national grid?Give brief idea.
Explain the working of any one cutting machine
in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com