In DC current-excitation to transformer, why it sucks more
current? Eventhough there is no power transfer between
primary and secondary? R is very low so it should suck less
current only na thn y its current increases?
Answer Posted / k.prakashchandra
I too add ?????????
Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
What do you mean by transformation ratio of instrument transformer?
What are locations arc protection relay is fixed.
Please elaborate th´evenin’s theorem?
what is the mechanical safety of DG ?
what is the difference between transformer,converter and transducer
Either It Possible a dc Motor to Run On Ac Drive [ Ex : ACS 800 , Yaskawa F7 ] If it is Possible How Pls Inform Me dinesh_elect_eng@yahoo.com
What is the formula to calculate the rating of a three phase miniature circuit breaker
how much GROUND & NEUTRAL VOLT maintain in data center.
2 v/500amp/hr to 1.80vpc at 20 degree celsious 2v/5ooamp/hr to 1.75 vpc at 77degree farren .this is the capacity of a battery .what is the meaning of this . can i get a detailed explenation
what is the difference between general inverter and solor inverter clerly explain plz
sir, iam a electrical engg graduate and i want to go in automation sector and for this i have decided to do industrial training for this,plz suggest me some good institute for the same in delhi,ncr. my degree percentage is 58%, can i get job after doing training, plz help....
What is the reason of polyphase induction motor tripping suddenly on high current during running at 70% laod? Motor IR , winding resistance & inductance balance. Motor no load current is balance and ok as per mgfr. data.
What is vaccum currcuit breaker.define with cause and where be use it device?
I have one ct of ratio 3000-2000/1 Amp its knee point voltage mentioned on name plate is 500-333/30mA-50mA at Vk/2. in secondary box there is three terminal named 1S1, 1S2, 1S3 then on which terminal obtained the knee point voltage ie 1S1-1S2 OR 1S1-1S3 & also specify the knee point voltage for the ratio 3000 from name plate.
i m in need of current rating chart of heavy duty pvc/xlpe, cu/al cables. can somebody provide me? if yes, plz send me at ashish_patel111@yahoo.com