what is radar type level transmitters and its basic
principle and how to calibrate it
Answer Posted / vikram kumbhekar
first of all we calculated the total lenth, then set 4mA at
zero level & max lenth at 20mA. When we send a RF freq
signal the time required to recieved the signal,that time
will be calculated by following formula
distance=velocity*time/2
in this way we get the value
Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
what is the current pay package for an instrumentation engineer having 2 years of experience in cryogenic technology???????
what is zero and span ?
diff between neutral ,ground,phase , earthing and shielding?
Explain why plc require in analog input 4-20amp & 0-10 volt?
please send the sample qustion paper for iocl written test ..
How to Calibrate Level Switch in field
What is the purpose of the analyzer in petrochemical plant?
Can anyone send most commonley asked Instrumentation questions and answers in cement industry please?
when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?
What is offset in a control system.
Why flow/pressure transmitter before control valve?
What happen if we install my pressure transmitter below the elevation of pipe in natural gas service?
Why do we floating DC in DC system.
why fuse block is not used for AI signal?
How to Calibrate Vortex Flow transmitter in field