why we use 3point starter in dc motor why not 4point
- 1 Answers
- 4371 Views
- I also Faced
- E-Mail Answers
Answer Posted / md.nehaluddin
The four-point starter eliminates the drawback of the three-point starter. In addition to the same three points that were in use with the three-point starter, the other side of the line, L1, is the fourth point brought to the starter when the arm is moved from the "Off" position. The coil of the holding magnet is connected across the line. The holding magnet and starting resistors function identical as in the three-point starter.that means the use of dc moter
| Is This Answer Correct ? | 3 Yes | 2 No |
Post New Answer View All Answers
Define hold time?
What are edge triggered flip flop and level triggered flip flop?
Define cut off frequency?
What is the necessity to use the special machines?
What is cut-off frequency?
could u plz send me a sample placement paper for hpcl trainee engg exam..(electronics& telecommunication stream)...thnku deepikameena1@gmail.com
what is the minimum and maximam trace width in PCB design? why trace is measured in mils? what is the use of via? why the crystal oscillator is placed near chip?
why BTS use 48 dc volt
Why collector is made larger than emitter and base?
why we using different type of microwave antenna we using like one is connected to MMU and one more is connected to other slot what is use of both antenna?
Consider a fixed subnet partition of a class B network number that will accommodate at least 76 networks. How many hosts can be on each network? Also mention how you calculated that.
Explain what is a latch?
what its mean 'inverter based technology' ? if we talk about refrigerators, splits ACs etc how it helps to produce & keep more coolness and chilled atmosphere ?
How will u plan a grounding network for a nw plant....
Which of the following protection methods is NOT supported by FlexiHoppers with FIU19(E)?
