I have two power supply.a)govt. power b)Captive power.3
phase load connected inside factory.when source change govt.
source to captive some motor rotate reverse. Is phase
sequence changes when if off & on?If I off generator & on it
again is it possible to get changed phase sequence??
- 4 Answers
- 5302 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / ali raza
yas u can change the phase sequence from main supply any one (govt. or captive) then your motor rotate in one direction at both supply in our plant also same condetion happend then we change the phase sequencein generator terminal
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
When calculation of fault current and fault Kva is to be done,why always we use per unit value and why we consider the base kva?
what is reactive power?, why its measured in VA ? is it transient behavior of system?
What is Plank's Law?
Why are the laminations insulated from each other?
Why is better to have a minimum ceiling voltage of 250% than 160%?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
what is the difference between capacitive and resistive voltage divider?
How to use earthing on shipments.
hi can anyone pls tell me the eee interview core questions asked in l&t
details of oil cell size of Breakdown voltage test of tranformer oil details as per Standardswith mushroom electrodes?
An active element is one which a. Supplies energy b. Absorbs energy c. Supplies energy and convert energy from one form to another
How to test the Secure Elite 440 Multi function meter working condition.
what can be the causes of capacitor start motor having a higher current that its actual
What is the most important precaution in any experiment with d.c. Shunt motor?
what is deffrence between squirral cage and wound rotor in IM?
