Answer Posted / ahmed mustafa
Transformers have errors arising from both Watt metric and
magnetizing current losses that cause deviation from the
ideal and the interconnection between them may have unequal
impedance, this can give rise to spill current through the
relay even if no fault has been detected.
| Is This Answer Correct ? | 28 Yes | 9 No |
Post New Answer View All Answers
I AM FROM ELECTRICAL ENGINEERING ? I AM ASPIRING FOR "BHEL".HOW I HAVE TO PREPARE .ON WHICH TOPICS TO BE CONCENTRATE MORE.PLEASE GIVE FULL DETAILS OF WRITTEN EXAM.
What is trip and closing coil in cb? Why need of them
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING)IO (current operating)?
why moisture formation found in XLPE Armoured cable outer sheath
Capacitor is load free component but why ampere meter shows current when capacitor bank breaker close?
What is the formula for selecting the cabels according to load? How to calculate what sq.mm cabel to be used?
What are factors to be considered while we selecting the Core Balance Current Transformer for Earth fault protection
i am an maintenance engineer. one distribution board have 5 feeder. recently its ELR trips frequently, but it take some times after trip( 10min,20min..)but 3 feeder no load. two feeder only loaded. i checked one feeder IR value all values are above 50Mohm.but B phase to Earth is only 9Mohm.any problem about low value
why does the magnetic balance tests at transformer?
What are the main advantages of generalized error co-efficients?
8. A DYNAMOMETER TYPE WATTMETER RESPONDS TO THE.......
How to calculate the heat load for a electrical room
low frequency protection why recomend?
Approach of a cooling tower is the difference between temperatures of what factors?
draw 3 phase rectifier diagram
