Answer Posted / qasim
basically we can calculate watt by
watt= (volts required)(Amperes)(Power Factor)
watt=V*I*P.F
and then for getting the kilowatt, divide the resulted answer by 1000 so by this method we can calculate correct relationship b/w Kw and Kv.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
We normally make oil soak pits under Transformers. Oil from soak pit goes to collection pit. We provide granules/pebbles under transformers. My question is weather granules/ pebbles to be filled in soak pit or not? if yes upto what level?
why can we use cosine wave instead of sine in ac supply as both have same rms vale and ripple factor
y we use neutral,all r told its used to for closed path..k its a just used to closed path,in a transmission line y we put same conductor used n both phase and neutral..if we use less than phase conductor in neutral mean we ll reduce cost its right r wrong..if we use mean any problem occur in transmission line..
How to know Resistance and Reactance value of main and aux winding of single phase capacitor start capacitor run induction motor to find capacitor value?
If you have an earth with pilecap then your resistance is really low. why and how?
how to calculate the lightning arrester conductor @ no of earth pits required
HOW DOES THE ELECTRONIC ENERGY METER WORKS?
ht side line to earth voltage
Damping resistor provided in open delta (tartiary) winding of a measuring PT at the incoming of a MV inverter drive panel is getting heated up. Can any body explain the reasons and suggest the remedy?
Determine a suitable number of slors and conductors per slot for the starter 1 winding of a 3 phase, 3300 V. SO Hz 300 rpm alternator. The diameter is 2.3 m
A cylindrical wire is compressed in length by 10%. The percentage decrease in the resistance will be?????
explain the mode of metal iranafer in Co,welding
As you achieve greater success with the company after some years, Will you like to be a share holder in our company?
WHY L-G FAULT IS MORE SEVERE IN TERMS OF RRRV?
Good day everyone,currently in our premise we using 30kw slip ring motor with resistance bank which we use as forward and reverse at conveyor bar handling. So,my question is how do we calculate the resistance bank which is suit the motor. Kindly,assist me... thank you
