Answer Posted / karna
It is used for measuring the insulation tester
| Is This Answer Correct ? | 0 Yes | 7 No |
Post New Answer View All Answers
Why 1/3 is used in symmetrical components?
what is per unit calculation?looking for simple and strong explanation thk u
What are the roles and responsibilities of electrical engineer in cement plant
in a simple IDMT relay we use neutral point of ct for earth fault then what is the requirement of neutral ct and cbct?
why output is out of phase in case of common emitter?
What is the minimum IR value of HT/ LT cable? Pls post separetely!!!!!
Is it possible to make a 5P10/ CT Ratio 50/1A Burden 5VA
which metal is use in shunt
What is the difference between the impedance percent and impedance voltage ?
ht side line to earth voltage
For group 1 , 2 whather i have to prepare my technical or general studies etc? and im graduate in ee engg. for wht posts im eligible for? please tell me!
can we use trip light with bus coupler?
what is basic difference betmeen normal & flame proof motor??
Why negative feedback is preferred in the control system?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
