i want to know how to calculate the battery capacity based
on the UPS . ex i want to run have one kva UPS Which should
run 10 hours ? in that case how many batteries to be
installed and what will be the AH Value .
- 2 Answers
- 3678 Views
- I also Faced
- E-Mail Answers
Answer Posted / markandeya
total number batteries=votage required/votage of indivedual
cell
Ah value of indivedual battery=1.5*current*time(hours)
for an example:
votage required is 240
cell voltage is 12
then we require 20 cells.
if load is 1 kVa time is 10 hrs
we need 60 ah is required
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com
What Is Connection APFC Panel In Compony.
what is the purpose of bypass mode in energy lighting transformer?
Can anyone explain me about the RLC based Impulse high voltage generator and how to and operation of Series resonant High voltage reactor...?
how will we calculate the copper wire load..
What happens if the Capacitive Voltage Transformer Primary neutral is not earthed. There is a CVT between Transformer and source, and the CVT neutral of the transformer is not earthed, does it effect the transformer while charging or does it effect the transformer charging process.
Explain the term parallel path in dc machin ?
why in the three pin plug all 3 pins are cutted ?
can we find the inductance of a induction motor?
what is the star delta connetion and how can do it a three phase motor with control witing with picture
what is the meaning of WYE and DELTA in Electric meter?
If symmetrical fault occurs at the terminal of a synchronous motor then how the motor will act...explain it..
sir,in our plant we r using SATEC PM172E power reading meeters in HT panel side it is monitoring the MB data smart viewer(sever).but last one week we did not get readings inthe server only available in meeter.tell me how communicate meter and server. and also what steps we take for checking.
how we decide wire gauge for ac or dc coil and what is the basic diff. B/w these two coil?
Explain cos(theta) and Sin(theta)
