Interested to Buy Any Domain ? << Click Here >> for more details...
A temperature sensor (RTD) connected via a temperature transmitter is adjusted to give an output of 4ma at 60 deg and 20 ma at 600 deg.
This output (4-20ma) from the transmitter is connected to an IGBT-inverter to control a high speed (-12,000 to +12,000 RPM) DC motor.
And in the inverter it is programmed as, for 4ma the motor speed will be -3,000 RPM and for 20ma the motor speed will be +10,000 RPM.
The question is : If the motor speed is +5,500 (RPM), what will be the temperature?
(-sign indicates that the motion is in reverse direction).
- 9 Answers
- 10479 Views
- I also Faced
- E-Mail Answers
Answer Posted / raj
13.84mA and temp will be 392 deg c
| Is This Answer Correct ? | 0 Yes | 4 No |
Post New Answer View All Answers
What is instrumentation technologists and mechanics?
How to fix back the valve actuator stem
Explain plc level and its type?
what is the difference between profibus and controlnet networking.
what is SIL 1 2 3
what different types of problems do occur while doing instrumentation commisioning and how to solve them? please explain in detail
What is the difference between modbus,fieldbus & profibus
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
Draw a group of instruments interlocked to a Pump & Motor?
Using your own examples solve a problem involving normal table. (experimental method and analysis)
Why not come out analog output in ABB EL3020 when display show correct value
I want to buy a seal kit of a pneumatic power cylinder.But I don't know it's specification.So please help me to know its specification.
Linear amplifier.
how to calibrate 0- 150 psi presure gauge by dead weght tester
What are the uses of orifice plates?
