Interested to Buy Any Domain ? << Click Here >> for more details...
Why electrical engineer use Cu Strip for transformer
neutral why not GI Strip? What if we use GI instead of Cu
does it affects the transformer performance.
- 7 Answers
- 18295 Views
- I also Faced
- E-Mail Answers
Answer Posted / shivshakti
Copper Material current carring capacity is more than GI material. so when ever any fault current occurs, they can easily pass through copper material instead of GI. so we are used copper
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
what is smart grid? why we use it? explain in detals bcoz i want give presentatin from it....
can i use 4 number of circuit breaker as single phase manual change over switch? if yes then how plz also send ckt diagram at nazimzamurad@gmail.com
How much no load current of synchronous motor
what is the difference between active power and reactive power and apparant power in practical as well as theoritical
What are the advantages and disadvantages of closed-loop control system?
Write down the name of 2 lady Bir Pratin of Bangladesh
At the starting of dc motor and syn.motor and induction motor high current flowing through the winding. Due to this the windings burnt out. To avoid this different types of starters are used. But incase of transformer what Will be used (At starting no emf is induced in the primary winding)?
Why neutral point is consider as zero potential?
how to compute kvar in substation feeder to improve power factor and sending voltage
WHATIS TIME CONSTANT? WHATIS ITS SIGNIFICANCE? ILLUSTRATE THROUGH EXAMLES.
What is pi controller?
why not starting switch first connect in direct on line starter?????
what is the effect of back reactive power on the generator ?
what is the main parts of transformer? how it is functioning? pls giv the ans briefly.
What is the need of earthing transformer for delta side of a transformer. (Think of a line section between a star/delta transformer at a grid substation and delta/star transformer at a village. An earthing transformer is there at the delta side of the star/delta transformer at grid substation). As there are no ground reference there will not be fault current if a one phase is grounded. Further L-L phase will be sensed by the primary side of star/delta transformer as a L-G fault. So why an earthing transformer is required at delta side
