what is the procedure to isolate flow a transmitter and
flushing it?
- 8 Answers
- 39143 Views
- Petrofac, I also Faced
- E-Mail Answers
Answer Posted / suresh agravat
First close root valve
second isolate manifold valve
open equaliser valve it was zero check procedure
open root valve
open manifold isolated valve
close equaliser valve it was taken in line procedure.
| Is This Answer Correct ? | 0 Yes | 8 No |
Post New Answer View All Answers
what is the imbustion control loop
what is basic difference between motion balance and force balance in pneumatic instrument?
Explain PID, ON/OFF, Controls
Pressure tx shows 1 mbar but we need 1000 mbar at this process condition .. how can we sort it out .
why we use the ac supply load cell>?can we use the dc supply load cell?advantages and disadvantage of the ac supply load cell?
What is 1:1 redundancy ?
can you send remote seal interface level transmitter calculation steps for oil water saperator.
how does we calibrate a square root flow transmitter ,give an example and explain it step by step like range calculation , calibration hook up series connection , zero check , and how to apply pressure , and if not geting proportional output then what should we do ?
how to control pid
Can any one tell me what type of question asked for instrumentation and control interview panel??? pls mail ramashankar.goel@gmail.com
what are the steps I have to deal with?
need to calculate flow rate with the help of dp range and orifice bore dia and size. range is 0 to 400 inwc and orifice size is 12 inch 150 # rf and bore dia is 7.180 inch. need to calculation for flow rate
Can any body help to get Rsemulator 5000 free from internet if possible then give me any link or any help .
What is cut off relay? And why use in PLC and DCS?
How do you identify between actual alarm and false alarm in a Temperature Transmitter in SCADA based Control System
