GIVE THE TEMPERATURE RANGE OF PLATIUM RESISTANCE THERMOMETER.
- 7 Answers
- 6735 Views
- DVC, I also Faced
- E-Mail Answers
Answer Posted / g.venkat narayanan
PLATINUM RESISTANCE THERMOMETER RANGE IS -200 DEG C (17.08
OHMS) TO 660 DEG C (337.03 OHMS)
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
Why upper weighing limit of electronics balance is 90% of the total weighing capacity?
Can please tell mi about SIOS, PRM, SERVER, and what is the diference between PIN LAN, PCS LAN,APC Server, and please send the Doc if possible for referance,mail id patil_amit17@yahoo.com
how will you check torque value during Factory acceptance Test for control valve/ESD ON/OFF VALE how will you confirm this torque value is being correct, Which document will you be refer.
what is the diffrence between pressure safety valve & pressure relief valve....pls
what is maxdna ?. explain about the software details.
how to calibrate Necleuonic level transmitter.?
need to calculate flow rate with the help of dp range and orifice bore dia and size. range is 0 to 400 inwc and orifice size is 12 inch 150 # rf and bore dia is 7.180 inch. need to calculation for flow rate
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
HOW TO CHOOSE FREAQUENCY IN FMCW TYPE RADAR INSTRUMENTS. DESIGN BASIS OR DESIGN CALCULATONS ?
Why ac supply load cell is used? Can we use the dc supply load cell?
Manipulation of dead wt. tester double piston type.
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
Why use ball valves on Gas pipelines instead of gate & or globe valves...means basic diffrence or use of these valves..how designers knows this type of valve with rating is required...
How earthing can be checked????
what is the criteria to decide conductor size of a cable ?
