what is full form of SMART
- 46 Answers
- 79648 Views
- Infosys, ITC Infotech, Lanco, Rosemount, Solvay, I also Faced
- E-Mail Answers
Answer Posted / mahbul hasan
yes, """it is correct answer in software project management"""
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is the reset offset and control system in instrumentation
what is interface level measurement.who can calibrate interface level measurement transmitter online
what is moisture probe? What are there types? What is there working principle and how they works? guys this is one of technical question I had ask in interview. If you know its answer please let me know. The interviewers were more interested in microwave moisture probe, so if you find its any link please just forward me on my mail id.avinash1200@gmail.com Thanks in advance.
What care will you take in the installation of control valves,SCADA,DCS and FOC in Oil and Gas Project?
please send me the inteview questions in IOCL
What is the difference between mmwc and mmwg?
how to do dynolab wind speed sensor loop test, how to simulate value,i have simulate mA 4-20mA but not responding in DCS faceplate, please kindly advice me any one.
i have used level transmitter in starch cooking preparation tank. tank total height 2mtr.sometime LT display shows some error value when tank is fully empty and diaphragm side i already checked okay no problem in diaphragm area. field cable checked 24volt and mA shows correct value while tank empty mA is 4mA. 4mA i needed that 0% but display showing 10% or 15% percentage values are varying continously please give any good solution for me.....
Valve positioner and actuators in detail.
What is instrumentation control?
Describe the typical instrumentation used in monitoring the performance of a shell and tube heat exchanger.
which processor is used in dcs.
Why not come out analog output in ABB EL3020 when display show correct value
How can test or measure the probe and extension cable to identify if the problem at the probe or cable or at the driver it self? (pleast notify the measuring method)
how to design orifice plate?what is the equation?
