how the flow rate is measured from a pipe with the help of
pressure?
- 1 Answers
- 4017 Views
- I also Faced
- E-Mail Answers
Answer Posted / vijayaragavan.c.m
Differential pressure flow measurement is old and reliable.
With the aid of microprocessor technology now discharge
coefficient calculations can be done in real time.
This are called multivariable mass flow meters.
By other side we can use typical differential pressure
devices such as (nozzles, orifice plate , etc).
The ISO5167 standard condenses all this experimental
information giving the formulas and procedures for
manufacturing a differential pressure flow measurement
device of the standard types with a predictable uncertainty.
| Is This Answer Correct ? | 3 Yes | 2 No |
Post New Answer View All Answers
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
What care will you take in the installation of control valves,SCADA,DCS and FOC in Oil and Gas Project?
What are the type of bonnets in the control valves?
while i check zero check for dp flow transmitter some fluctuating came (0 to 458 kg/h) what is the reason?
NPN transistor, SCR, Zener diode, LED, Varactor diode, Vortex meter, RTD, Resistor, Crystal
where proximity sensor installed on tank in loading arm application
How u will setup SPI(2007) on Citrix Server (Thin Client Mode)? Plz Justify?
Why 4-20 amps is being used in instruments? Why cant we use any other range instead of 4-20 amps? Why only 4 amps is taken as lower limit and why 20 amps is taken as the higher limit?
Difference between dcs and plc including date processing and architecture.
I have energy meter for educational project having 0.5s class but my friend need 0.2s class meter , which one is good for that purpose and what is the actual difference of that two classes , need very easy example also.??
how to calculate the total flow in square root
What is loop1 and loop2 in MTS LT?
What is the meaning of wet leg
Define the terms Accuracy, precission, Spam, process tolerance while doing calibration of an instrument? Explaini with an example?
why we take %i0.0 as input for twido plc
