Answer Posted / prasath
THE TEMPERATURE DIFFERENCE BETWEEN TWO DISSIMILAR METALS ARE JOINED AN EMF IN INDUCED AT THE JUNCTION THIS IS SEEBACK EFFECT.
| Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
how do calibrate the valves.. with clear manual
please send the drdo exam paper
With N nodes and B branches what will have a network ???
Make a ladder diagram on LSL valve will close, on PSL valve will open and start the motor
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
where are following valves are applicable to install. can any valve be installed any line. globe valve butterfly valve boll valve gate valve
what is easiest way to read STL language in PLC?
how 3 out of 2 Logic/interlocks works? give brief explanation with help of diagram.
3. Differentiate between ultrasonic flowmeter and radar type flow meter.
field bus transmitter calibration procedure tell me
why using negative supply for bentley nevada vibration system ?
whatis range of marcury filled tempereture gague
why we use cascade control and feed foreword control in 3 element control of boiler drum ?what is feed forward and cascade control system ?
For crude application in floating roof tank, how to calibrate a DP Transmitter? How is the floating roof weight considered?
our kks tagging is crossing more than 12 character please suggest how to take tags in the DCS
