how the lap length is calculated in reinforcement of 110mm
dia steel of Length 15.00 mtrs. & grade of concrete is M20
- 22 Answers
- 99657 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / ramesh konduru
For any dia the lap length should be calculated as per IS:
456 is 50 times the dia of he bar.
| Is This Answer Correct ? | 67 Yes | 18 No |
Post New Answer View All Answers
What is the likely strength of a 1:2:4 concrete mix?
hi, i am doing my B.tech third year and i want to have a job in Genpact...So can you help me which kind of job would be more appropriate for me in such a company and How should i prepare for an interview?
Hi.. Can i get hel in finding HPCL previous year question paper? plz help me in finding thiss..
i) Distinguish between Theodolite and dumpy Level? (Marks-8) ii)Distinguish between Viscous and Turbulent flow? (Marks-8) iii) Distinguish between nominal and design mix? iv) What is standard sand? v) Explain the term plane stress? Vi) Differentiate between principal plane and principal axis? Vii) write short notes on Elastic limit of structural steel? viii) Write short notes on stress concentration? ix) write short notes on "Grading of Sand" ? x) How many grades of concrete are there under standard concrete?
What is the exception critarea of cube?
Why reinforcement done in shorter span in two way slabs
what is the permanent solution applied for restoration of leaning tower of pisa?
Why are steel plates inserted inside bearings in elastomeric bearing?
Types of column foundation and how to calculate its steel quantity.
Floor to floor high of domestic building is 3m design a quarter turn staircase starting assume taken give a suitable diagram of it?
How to calculate or what is the process of calculation for making 1Metre squre area by AAC Blok which quantity of Cement, Sand & Chips are to be required?
what are the duties of Site Engineer in work site?
What is the veriplus for ellips card length formula (major axis 3.4m,minar axis 2.6m spacing 0.2m
What are the alternate material for steel, Sand and aggregate
give me the rate analysis for Bituminous Macadam and SDBC
