there are two candidates p and q in an election.During the
campaign,40% of the voters promised to vote for P ,and rest
for Q.however, on the day of election 15% of the voter went
back on their promise to vote for P and instead voted for Q.
25% of the voters went back on their promise to vote for Q
and instead voted for P.suppose,P lost by two votes,then
what was the total no. of voters.
- 4 Answers
- 17865 Views
- GATE, I also Faced
- E-Mail Answers
Answer Posted / abhi
100
| Is This Answer Correct ? | 13 Yes | 1 No |
Post New Answer View All Answers
HI, can anybody give details about GAS TREATMENT PLANT CONSTRUCTION,as INSTRUMENTATION ENGINEER what are the responsibilites.what are the instruments mainly instrumentation engineer will deal with
1.what is the effect of vapour presuure in orifice plate flow measurement 2.which is more effective 2 pressure sensors or one single differential pressure sensor in orifice plate measurement 3.how to design a v/i converter and i/v converter 4.how many type of thermocouple are there 5.how many leads are there in thermocouple measurement 6.how pressure sensors are connected in level measurement in differential pressure method 7.what is the output of capacitive pressure sensor (ac or dc),how its o/p is signal charactarized 8.what is the physical meaning of discharge coeeficient,why it is calculated,orifice plate what is its value,why it is less than 1,Q at upstream is equal to or not equal to Q at downstream of orifice plate why?what is vena contracta in orifice plate 9.why rotameter is called variable area flowmeter,it can measure flow even if area is not varying,why it is made tapered 10.design a 10 bit counter ,which counter you will prefer 11.how to remove self heating error in RTD 12.which is more sensitive pt100 or pt50 13.why thermocouple are connected in parallel 14.what is lead contact error in RTD,how to avoid 15.what is P,PI,PID,PD controller,why there is no ID controller 16.what is override,split range,sequential,ratio,feedforward,cascade controller 17.why we moved from SR to JK and then JK to master slave JK flipflop,give correct reason 18.how to measure level of a closed container which contains vapour and liquid,remember no vapour gas should be leaked,so ultrasonic and capacitive is not an option,design another method 19.how to design horse race counter including sensors and signal conditioning element 20.what is bevelling
why we use the ac supply load cell>?can we use the dc supply load cell?advantages and disadvantage of the ac supply load cell?
what is commisioning procedure,2)what is is the main work in commisioning in the field tx to dcs, plz send me detail
can anyone can let me know in Eurotron Micro cal 2+ calibrator in milli amps source mode we are not able to get 20 milli amps output it only produces 1.52 milli amps out, but display shows increase in milli amps , and err6 displays, let me know how to remove the err 6.
What is frequency factor in massflow meter? When using frequency output?
What is the meaning of wet leg
what diffrence b/w plc s7200,300,400
send me model hpcl questions pleas..........my mail id mohideen.dharvesh@gmail.com
Give Detail information about plc,dcs,and scada system?
how to calibrate and troubleshooting of leveltroll?
What do you know about gail?
what is the procedure for auto tune in masoneialn 12300 series displacer type transmitter?
what is the PC interface and software for connection to ABB logic module “ LM011-CE18RAC “ ( for Programming ) ??
model question paper of instrumentation for Jindal GET 2010.plz reply sudhanshukumar08@yahoo.com
